Troubleshooting Guide - Ramsey Winch H-89 Bedienungsanleitung

CONDITIONS
CLUTCH INOPERATIVE OR
BINDS UP
LOAD DRIFTS
OIL LEAKS FROM WINCH
WINCH RUNS TOO SLOW
ROPE DRUM WILL NOT
FREESPOOL
ROPE BIRDNESTS WHEN
CLUTCH IS DISENGAGED
HYDRAULIC FLUID LEAKS
OUT HOLE IN MOTOR
ADAPTER
TROUBLE SHOOTING GUIDE
POSSIBLE CAUSE
1. Dry or rusted shaft.
1. Bent yoke or linkage.
3. Debris in clutch.
4. Clutch not disengaging.
1. Holding brake has become
worn.
2. Holding brake out of
adjustment.
3. Incorrect hydraulic system.
4. Load is greater than rated
capacity.
1. Seals damaged or
Worn.
2. Too much oil.
3. Damaged Gasket.
1. Low flow rate.
2. Hydraulic motor worn
1. Clutch not disengaged.
2. Winch not mounted squarely,
causing end bearing to bind
drum.
1. Drag brake disc worn.
1. Hydraulic motor shaft
seal damaged.
1. Clean and lubricate.
2. Replace yoke or shaft
assembly.
3. Clean and lubricate.
4. Adjust clutch air shifter
(See section under Main-
1. Replace brake disc (See
Servicing of the Oil
Cooled Safety Brake).
2. Turn adjusting bolt clock-
wise 1/4 turn until load
does not drift
3. Check hydraulic system. (See
4. Reduce load.
1. Replace seal.
2. Drain excess oil. Refer to
3.
1. Check flow rate. Refer to
2. Replace motor.
1. Check air pressure to clutch
2. Check mounting (See Winch
1. Replace discs.
1. Replace seal.
11
CORRECTION
tenance).
Hydraulic System Require-
ments).
Winch Maintenance.
Replace gasket.
Hydraulic System
Requirements.
cylinder 4,8 bar (70 psi) min.
required (See Adjustment of
Air Clutch Shifter).
Mounting).