SCHUBERTH C3 Pro Gebrauchsanweisung Seite 42

C. THE HELMET
4. Mount the cheek pad using the
three pins on the red plugs and
sockets. Ensure that the head
strap cushion's plastic strap with
the round holes is inserted over
the rear cheek cushion pin.
5. Repeat points 1 to 4 to mount the
cheek pad on the other side.
6. Reinsert the neck collar by first
inserting the guide pins into the
front plugs and sockets on the
lower helmet edge on both sides
and then mount the neck collar
into the guide gap piece by piece.
Note:
Ensure that the A.R.O.S. straps are not twisted.
Note:
When inserting the crown liner, make sure that the headband
ventilation cut-outs are positioned over the ventilation
channels at the back of the helmet and that the crown liner
runs centrally between the two ventilation channels.
82
.
Caution:
Never ride when parts of the inner lining have been removed.
Caution:
Excessive heat (e.g. exhaust heat) can cause damage to the
inner lining!
Note:
To avoid damage to the inner lining and inner shell, do not
hang the helmet over the mirrors or handlebar grips.
Note:
When replacing the cheek pads,
the Anti-Roll-Off System must be
properly joined to the chinstrap.
For this purpose, the loops on the
free ends of the A.R.O.S. straps –
as shown in the illustration below –
must enclose the corresponding
ends of the chinstrap and the
A.R.O.S. straps must not be twisted
or knotted.
Note:
For size 54 /55 helmets, also ensure
that the A.R.O.S. straps are always
threaded through the additional
loops in the back of the neck area.
83