SCHUBERTH C3 Pro Gebrauchsanweisung Seite 36

C. THE HELMET
3. Make sure that the face shield
mechanism is functioning properly
by opening the face shield once to
its maximum extent.
®
PINloCk lENSE
Fitting
1. Lay the Pinlock ® lense in the face
shield in such a way that one side
of it is already slotted into the
locking pin and the silicone seal is
on the side facing the face shield.
2. Now grasp the other side of the
Pinlock ® lense by its upper and
lower transverse edges and use
your index finger to gently press
the end of the visor into a slight
"S" shape. Now you can easily
guide the slot over the locking pin
and release the Pinlock ® lense into
place.
70
3. The Pinlock ® lense should now be
positioned in the face shield with
its lower edge parallel to the lower
edge of the face shield. If you
need to change the positioning of
the Pinlock ® lense, use the balls of
your thumbs to gently bend the
face shield apart until the inner
visor can be adjusted as required.
4. Check all around the Pinlock
to make sure that the silicone seal
fits tightly and evenly against the
face shield. Only if this is the case
will the anti-misting properties
function properly.
5. If you have not done so already,
remove the protective film from
the Pinlock ® lense
Removal
1. Before starting to remove the
Pinlock ® lense, first lay the face
shield on a soft, clean cloth so
that its top edge is facing you.
2. To reduce the pretensioning of the
Pinlock ® lense slightly if necessary,
use the balls of your thumbs to
carefully bend the face shield
sufficiently apart while applying
pressure with your thumbs to
release the Pinlock ® lense and
move it approx. 2-3 mm forward.
®
lense
71