Mounting The Appliance; Connecting The Power Supply - STIEBEL ELTRON DHB-E 11 SLi electronic Bedienung Und Installation

Installation
Assembly
10.2.8 Installing the DMB flow limiter
Position the flow limiter provided in the cold water inlet of
the appliance.
A second flow limiter is provided with the DHB-E 18/21/24 SLi.
Install the flow limiter with an output corresponding to that of
the appliance.
Flow limiter, see "flow rate limit" in chapter "Specification":
4.0 l/min = pink
7.5 l/min = blue
8.5 l/min = green

10.2.9 Mounting the appliance

The cable grommet pointing towards the wall may hinder the
mounting of the appliance close to the wall. To prevent such prob-
lems, it is advisable to briefly press the cable grommet from be-
hind into the back panel, to reduce the stiffness or the grommet.
Remove the fixing toggle from the upper part of the back
panel (diagram "Mounting the appliance").
Route the power cable from behind through the cable grom-
met until it rests against the cable sheath. Align the power
cable. If the cross-section of the power cable is greater
than 6 mm, enlarge the hole in the cable grommet (see also
"Power supply for larger cross-sections").
Push the appliance over the stud of the mounting bracket, so
that it breaks through the soft seal. If necessary pierce the
soft seal with a screwdriver.
Put the fixing toggle onto the stud of the mounting bracket
that penetrates the back panel.
Press the back panel firmly into place and lock the fixing tog-
gle by turning it through 90°.
www.stiebel-eltron.com
10.2.10 Finalising the water connection

10.2.11 Connecting the power supply

Connect the power cable to the mains terminal (see chapter
"Wiring diagram").
WARNING Electrocution
Ensure that the appliance is earthed.
DHB-E SLi | A electronic | 25