Establishing The Electrical Connection En; Electric Shock; Operation - Abicor Binzel FES-200 W3 Betriebsanleitung

7 Operation

6.3 Establishing the electrical connection

Electric shock

Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
Mains cable and mains plug are pre-mounted. For the mains voltage and the fuse protection, please refer to:
 3.1 Technical data on page EN-9
 3.3 Nameplate on page EN-10
1 Plug in the mains plug.
7 Operation
Health risk caused by harmful dust
Before and during operation, please observe the following:
• The fume extraction system must not be operated with an open dust collecting drawer.
• During operation and fume extraction, the complete fume extraction system must be kept closed.
• After having switched off the fume extraction system, wait at least one minute before opening the
NOTICE
• Use the FES-200 W3 fume extraction system only in areas with sufficient ventilation.
• After each use, the dust collecting drawer must be checked.
• In case of a filling level of 2/3 or more, the dust collecting drawer must be emptied according to the
 Fig. 9 Control elements on page EN-21
1 Plug the mains plug into the socket.
2 Set the rocker switch (2) on the fume extraction system to the Manual position.
EN - 20
WARNING
WARNING
cover of the dust collecting drawer.
regulations.
 5.1 Emptying the dust collecting drawer on page EN-13
FES-200 W3