Hayward TigerShark series Bedienungsanleitung Seite 23

IMPORTANT: check the cable regularly to make sure that it has no external damage.
If the supply cord is damaged, it must be replace by the manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
SOLUTIONS TO FREQUENTLY ASKED QUESTIONS:
TIGERSHARK WILL NOT CLIMB THE WALLS
Clean the filter. It might be clogged or too heavy due to waste or to too much algaecide being present.
The brushes might be worn. Examine them and change them if necessary.
Check the electrical installation and make sure that the voltage is correct: 230 V 50/60Hz
The water temperature should be greater than 15°C, otherwise the PVC brushes might stiffen and affect TigerShark's capacity
to climb the walls.
Replace the PVC brushes with foam brushes. Ensure that the handle is in the diagonal position.
TIGERSHARK HAS LOST SUCTION
Clean the filter. It might be clogged and be preventing suction.
Check that the feeds in the bottom cover are not blocked, and clean them if necessary. Check the Venturi tube for any waste
or damage. Clean or replace if necessary.
An intake that clips onto the bottom cover is available from your dealer. This makes it possible to achieve a higher speed and
thus improved suction of small or heavy waste.
TIGERSHARK STOPS SUDDENLY WHILE IT IS CLEANING
The Venturi tube might be clogged with waste. Check and clean if necessary, by following the instructions in the chapter on
maintenance.
The bearings of the brushes or the tracks are stuck. Check whether there is any dirt; clean them if necessary.
Put the TigerShark back in the water and switch it back on. In order to protect the fragile components, TigerShark will cut out
automatically if it is removed from the water.
TIGERSHARK IS NOT WORKING ANY MORE
Check the socket for the voltage surge switch system to ensure that the power supply is correct.
Check the power of the power supply box per section (see below).
Check the floating cable per section
CHECKING THE POWER SUPPLY BOX
The power supply box is protected by an automatic circuit that interrupts the current. To switch it back on, move to the "OFF"
position and then to the "ON" position.
The power supply box is equipped with an internal circuit. The voltage across terminals 1 and 2 of the power supply socket
for the cleaner must be 24 V ⎓.
Hayward only guarantees the quality, performance and safety of its products when assembled with genuine Hayward manufactured parts.
Use of non genuine Hayward manufactured parts will void all warranty.
Page 8 of 14 TigerShark / TigerShark QC / TigerShark 2 Rev. B