Hayward TigerShark series Bedienungsanleitung Seite 20

Use:
Take some time to become acquainted with your TigerShark by looking at the drawings (Figures 1 and 2).
Throughout the handbook we refer to these drawings when we are talking about the various components
of TigerShark.
1. Choose a 230 V socket (outlet) that is close and protected from short-circuits. Fit a 30 mA differential protection device
to protect people from electric shock caused by a possible break in the electrical insulation.
2. Install the power
of the pool. The power supply box should be at least 3.5 metres from the edge of the pool (Figure 1a).
The standard length of the TigerShark cable is 16.76 metres (TigerShark 2 : 30 metres).
3. Plug the floating cable into the power supply box.
Caution: use the original power supply box only.
4. TigerShark has an adaptable handle (3). The handle should be locked in the diagonal position in order
to guarantee optimum cleaning results. Reverse the position of the handle after use every time it is used (Figure 1b) to
enable the cord to be wound up without twisting.
5. Place TigerShark in the pool. It will sink gently to the bottom of the pool as it gradually empties itself
of the air that it contains.
6. Plug the power supply box into the socket and switch on the appliance. TigerShark will programme
a self-diagnostic test for a few minutes before it starts cleaning the pool.
Caution:
DO NOT SWITCH TigerShark ON OUTSIDE THE WATER. You might damage the pump and render the warranty NULL
AND VOID.
7. TigerShark switches off automatically after a 4-hour cycle (TigerShark 2 : 7 hours).
If your pool is clean in under 4 hours, you can switch off the cleaner by switching off the power supply box.
If a second clean is necessary, wait for 30 seconds before switching back on again.
8. Once the pool is clean, switch off the power supply box before you take TigerShark out of the water.
9. Take TigerShark out of the water from the shallow end of the pool by pulling the cable until the cleaner comes up to the
surface. Then, lift it out gently by using the handle, NOT the cable.
CAUTION: while pulling the cable, wind it in around both of your hands and above all not around your arm. To make
TigerShark last, remove the water from it after use, every time it is used.
DO NOT GO INTO THE POOL WHILE TigerShark IS OPERATING.
Check the height of the waterline on TigerShark:
- Ensure that the filter is clean.
- Put the cleaner in the water and observe the height of the waterline on the cleaner. For this purpose, let it perform several
cleaning cycles in order to determine an average height.
- Once the waterline is settled, if the cleaner regularly makes excessive rattling noises, takes air in through the bottom cover,
climbs up the edge of the wall instead of going back the other way, or if it tends to stagnate in the same zone of the pool, it
is probable that TigerShark is climbing too high: install the reducer kit.
Hayward only guarantees the quality, performance and safety of its products when assembled with genuine Hayward manufactured parts.
Page 5 of 14
supply box (1) so
Use of non genuine Hayward manufactured parts will void all warranty.
TigerShark / TigerShark QC / TigerShark 2
that your TigerShark can reach all of the walls/surfaces
Rev. B