Electrical Installation; Adjustment; Commissioning; Transport, Storage, Maintenance And Disposal - Siko SG60 Originalmontageanleitung

SG60, SG120

Adjustment

4.3 Electrical installation

For details on the electrical connections please refer to the encoder docu-
mentation.
5 Adjustment
For reference point adjusting the encoder must only be rotated in counter-
NOTICE
clockwise direction.
1. For adjusting the reference point loosen the screws
2. Rotate the encoder in arrow direction until the reference point is

6 Commissioning

Please ensure that the instructions given in chapter
cal and electrical connection are followed. This will ensure correct instal-
lation and the operating reliability of the device.
Before starting check again:
• correct polarity of the supply voltage.
• correct cable connection.
• correct mounting of the device.

7 Transport, Storage, Maintenance and Disposal

Transport and storage
Handle, transport and store wire-actuated encoder with care. Pay atten-
tion to the following points:
• Transport and / or store wire-actuated encoder in the unopened origi-
• Protect wire-actuated encoder from harmful physical influences
• Do not damage connections through mechanical or thermal impact.
• Prior to installation inspect the wire-actuated encoder for transport
SG60, SG120 · Date 24.10.2017 · Art. No. 84105 · Mod. status 319/17
until the encoder can be turned.
reached; then re-tighten the screws.
nal packaging.
including dust, heat and humidity.
damages. Do not install damaged wire-actuated encoders.
English
Fig. 4)
(see
2
4
regarding mechani-
19