Electrical Installation - Siko IKM360R Originalmontageanleitung

IKM360R
Installation
-X
Fig. 2: Number of axis 2

4.2 Electrical installation

Destruction of parts of equipment and loss of regulation control
WARNING
` All lines for connecting the inclinometer must be shielded.
` Never wire or disconnect electrical connections while they are live.
` Perform wiring work in the de-energized state only.
` Use strands with suitable ferrules.
` Ground (GND) nust be connected with the protective earth conduc-
` Wiring to the screen and ground (GND) must be secured to a good
` Check all lines and plug connections before switching on the device.
` Switch on operating voltage together with the downstream electronic
With IP6K9K type of protection requirement, take particular care to use a
NOTICE
suitable plug connector and a tightening torque of 0.4 ... 0.6 Nm.
Basically, all connections are protected against external interference.
NOTICE
Choose a place of operation that excludes inductive or capacitive interfer-
ence influences on the inclinometer. When mounting the system keep a
maximum possible distance from lines loaded with interference. If neces-
sary, provide additional installations including screening shields or met-
allized housings.
Connection type
• E12: plug pin 5 pole + socket contact 5 pole (M12 A coded).
For mating connector accessories see chapter 7.
IKM360R · Date 21.01.2021 · Art. No. 90437 · Mod. status 222/20
X = 0°
1
tor (PE).
point. Ensure that the connection of the screen and earth is made to a
large surface area with a sound connection to minimise impedance.
unit (e. g., control unit).
+X
2
English
X-axis
1
Y-axis
2
+Y
Y = 0°
-Y
17