Encoder Mounting - Siko SG60 Originalmontageanleitung

SG60, SG120
18 Installation
NOTICE

4.2 Encoder mounting

Encoder starting and operational torques must not exceed the maximum
admissible value of 1 Ncm.
The wire actuated unit is ready to be fitted to an incremental or absolute
encoder (Fig. 4).
Mounting:
1. Check whether encoders
comply .
6
2. Loosen screws
2
opening in the flange.
7
3. Assemble encoder and wire actuated unit together so that encod-
ers shaft fits into compensation coupling
unscrewed).
4. Mount the servo flanges
5. Slowly pull out the wire connector
pling until the screw
Notice! Tighten the threaded pin whilst keeping the wire tense.
6. Tighten screws uniformly
Mount without force!
7. Finally close the bore
dirt.
7
1
Fig. 4: Encoder mounting
SG60, SG120 · Date 24.10.2017 · Art. No. 84105 · Mod. status 319/17
and compensation couplings diameter
4
and servo flanges
3
to fix the encoder.
3
to turn the compensation cou-
1
is accessible through the flanges opening
5
to fix the servo flanges to the encoder.
2
with the plastic plug
7
8
9
6 5
4
; remove plastic plug
(screw must be
6 5
to avoid ingress of
8
Use SW2 mm hex.
9
key
3
2
(6x)
English
of the
8
.
7