Electrical Installation - Siko IH5828 Originalmontageanleitung

IH5828
Installation
• No forces must be transferred through the housing. Forces must act
Mounting instructions
Please handle the encoder carefully as it is a high-precision device:
• disassemble or open the encoder.
• link encoder's shaft with rigid couplings as this would expose the
• knock on casing or shaft; the encoder's inner components could be
• machine (bore, mill ...) flange or shaft. This could lead to severe dam-
• exceed the values for the maximum axial and radial shaft load.
• mount the encoder incorrectly.
Fig. 1: Mounting instructions

4.2 Electrical installation

Destruction of parts of equipment and loss of regulation control
WARNING
` All lines for connecting the incremental encoder must be shielded.
` Do not disconnect or close live connections.
` Perform wiring work in the de-energized state only.
` Use strands with suitable ferrules.
` Check all lines and plug connections before switching on the device.
` Switch on operating voltage together with the downstream electronic
` Unconnected signal lines must be provided with a resistor (e. g.: R =
IH5828 · Date 20.10.2020 · Art. No. 89304 · Mod. status 239/20
exclusively on the shaft of the instrument.
encoder's shaft bearing to high forces.
damaged.
age inside the encoder.
unit (e. g., control unit).
10 kOhm) and connected to earth.
English 17