Programming Functions - ECG MTD 206 VSS Bedienungsanleitung

Microwave power output table
Sequence Display
1 P100
2 P 80
3 P 50
4 P 30
5 P 10

3. Programming functions

1) Set the time according to instructions, see Setting the time.
2) Set the cooking time, you can select a maximum of 3 preparation stages. If one of the preparation
stages is defrosting, you should set it as the fi rst (see Stage cooking).
Clock/pre-set
3) Press the
4) Using set the hours in the range 0-23 and confi rm by pressing the
the two minute digits will begin to fl
5) Using set the minutes in the range 0-59 and confi rm by pressing the Quick Start/Start but-
ton.
6) The microwave door must be closed as soon as the time appears on the display, which you just
set, the oven will beep twice and begin to cook.
4. Rapid cooking
By pressing the Quick Start/Start button you will start cooking at 100% for 1 minute. Every time
this button is pressed again the cooking time is increased by another 1 minute. Maximum possible
setting is 95 minutes.
5. Defrosting based on weight
1) Press the Defrost By W.T. button. (Defrost by weight), the display will show "dEF1".
2) By turning set the weight of the food. A "g" will light up on the display.
3) Start the defrost by pressing the Quick Start/Start button.
6. Defrosting based on time
1) Press the Defrost By Time button and "dEF2" will appear on the display.
2) By turning set the length of food defrosting time with a maximum duration of 95 minutes.
3) Start the defrost by pressing the Quick Start/Start button.
61
Microwave power output
100 %
80 %
50 %
30 %
10 %
button, the hour digits will start to fl ash.
ash.
EN
button,
Clock/pre-set