Programming Functions - ECG MTD 206 VSS Bedienungsanleitung

Example: If you wish to set the heating of food to 80% microwave power for a period of 20 minutes, the setup is as follows:
1) Press the Microwave button and "P100" will appear on the display.
2) Using set 80% power.
3) Confirm by pressing the Microwave button and "P 80" will appear on the display.
4) Turn the until "20:00" is shown on the display.
5) By pressing the Quick Start/Start button you will start the cooking process. By pressing the Cancel/Stop button you will cancel the
setting.
Note: When setting the cooking time parameter for cooking food the interval values change from seconds to minutes depending on
the total time, see the following:
Total cooking time Changes by
for 0–1 min : 5 seconds
for 1–5 min : 10 seconds
for 5–10 min : 30 seconds
for 10–30 min : 1 minute
for 30–95 min : 5 minutes
Microwave power output table
Sequence Display
1 P100
2
3
4
5

3. Programming functions

1) Set the time according to instructions, see Setting the time.
2) Set the cooking time, you can select a maximum of 3 preparation stages. If one of the preparation stages is defrosting, you should set
it as the first (see Stage cooking).
3) Press the Clock/Pre-set button, the hour digits will start to flash.
4) Using set the hours in the range 0-23 and confirm by pressing the Clock/Pre-set button, the two minute digits will begin to flash.
5) Using set the minutes in the range 0-59 and confirm by pressing the Quick Start/Start button.
6) The microwave door must be closed as soon as the time appears on the display, which you just set, the oven will beep twice and begin
to cook.
4. Rapid cooking
By pressing the Quick Start/Start button you will start cooking at 100% for 1 minute. Every time this button is pressed again the cooking
time is increased by another 1 minute. Maximum possible setting is 95 minutes.
5. Defrosting based on weight
1) Press the Defrost By W.T. button. (Defrost by weight), the display will show "dEF1".
2) By turning set the weight of the food. A "g" will light up on the display.
3) Start the defrost by pressing the Quick Start/Start button.
6. Defrosting based on time
1) Press the Defrost By Time button and "dEF2" will appear on the display.
2) By turning set the length of food defrosting time with a maximum duration of 95 minutes.
3) Start the defrost by pressing the Quick Start/Start button.
7. Cooking according to stages
For cooking a maximum of 3 stages may be set. If one of the preparation stages is defrosting, you should set it as the first.
Example: If you want to cook a food for a time of 20 minutes at 100% power and then cook for 5 minutes at a power output of 80 %, the
setup is as follows:
56
Microwave power output
100 %
P 80 80 %
P 50 50 %
P 30 30 %
P 10 10 %