Connecting; Wall Mounting; Hearing Aid Compatible; T-Net Set-Up - AUDIOLINE TEL4clip Bedienungsanleitung

2.2

CONNECTING

Connect the telephone cable provided to the telephone jack
and the telephone socket on the underside of the
telephone. Then feed the cable through the cable guide and
away from the telephone either to the top or to the bottom.
The AUDIOLINE TELEFON 4clip works using the TTD
system (Touch-Tone Dialling).
2.3

WALL MOUNTING

Your AUDIOLINE TELEPHONE 4clip is also suitable for
wall mounting. Use two screws for fixing it to the wall. Drill
two holes 83 mm apart and leave the screws protruding 5
mm from the wall. Now place the telephone over the screws
and push down slightly. When the telephone is used on a
table, the receiver hanging hook must be in the flush
position as shown in diagram A (factory setting). When
mounting on the wall, the telephone receiver hanging hook
is pulled out and rotated. This is shown in diagram B.
A)
2.4

HEARING AID COMPATIBLE

The telephone has a special circuit working on the basis of
induction for transmitting speech to hearing aids. Please set
your hearing aid to "T".
2.5

T-NET SET-UP

Your AUDIOLINE TELEPHONE 4clip supports the most
important DEUTSCHE TELEKOM added value functions
(e.g. brokering, call waiting, three-way conference, etc.).
More information can be found in item 5. Please contact
DEUTSCHE TELEKOM to gain access to these functions
(some of which are subject to charge).
2.6

ADJUSTING THE DISPLAY CONTRAST

The display contrast can be adjusted by means of the
"CONTRAST" slide switch on the left-hand side of the
receiver.
16
B)