Wall Mounting; Adjusting The Display Contrast; 3.10 Basic Settings - AUDIOLINE TEL38CLIP Bedienungsanleitung

3.8

Wall mounting

Your telephone is also suitable for wall mounting. Use two screws for fixing. Drill
two holes vertically, one above the other, 67 mm apart, and leave the screws
protruding from the wall by 5mm. Now place the telephone without the desk
support over the screws and push it slightly downwards.
There is a small hanging device in the receiver rest to prevent the receiver from
falling when it is placed on the rest with the telephone mounted on the wall. Using
a small screwdriver, turn this hanging device until a small hook appears at the
upper end.
If you are using the telephone fitted to the wall, you can hang the receiver on the
telephone without hanging up. You will find a small hook for this purpose at the
upper end of the receiver rest.
3.9

Adjusting the display contrast

With the receiver on the hook, the display contrast can be adjusted using the
buttons.

3.10 Basic settings

Before you can use your telephone, a few basic settings have to be made.
These include entering the current date and time as well as your local dialling
code and the country dialling code for Germany.
Some notes on the local dialling code and the country code
Telephone numbers are always shown in the display with the local dialling code or,
in the case of international calls, also with the appropriate country code. If these
numbers are dialled directly from the caller list, the dialling code can of course be
omitted with local calls. Therefore, you should enter your local dialling code
(always starting with the 0) and the country code for Germany (0049).
After the batteries have been fitted, the display shows the message
ORTSVORWAHL and the cursor will flash in the first position.
Note: If the message ORTSVORWAHL no longer appears or if you have to
change the time from winter to summer time, press the save button
seconds.
28
- Commissioning -
for 4