Operation; Taking A Call; Taking Two Calls; Making A Call - AUDIOLINE DECT6800 Bundle Bedienungsanleitung

6

Operation

6.1

Taking a call

When a call is received, both the handset and base station ring.
Remove the handset from the base station to take the call. To end the call, replace
the handset in the base station.
V
W
Note: When the handset rings, the ringing tone on the handset can be switched
off for this incoming call.
SILENT
6.2

Taking two calls

You will hear acoustic signals (call waiting) if a second call is received while you are
carrying out a telephone conversation. The number of the second caller appears in
the display. You can take the second call and then switch between the two callers as
necessary. One caller is put on hold while you converse with the other.
V, 2
Note: In order to use the supplementary services provided by Deutschen
Telekom, the Recall time must be set to 300 ms (refer to Chapter 13.3).
Caution: The caller number display and call waiting signal are optional ser-
vices provided by your telephone network provider. The caller number ap-
pears in the display if the service is offered by your telephone network pro-
vider. Contact your network provider for further information.
6.3

Making a call

Z
V
If you have entered an incorrect digit, use the Navigation button X to move
Note:
the cursor and press the Display button CLEAR to delete individual digits
from the phone number.
It is also possible to press the Call button V first to obtain an outside line. In the case
of private branch exchanges, it is necessary to dial a specific number (e.g. 9" or 0")
in order to obtain the dialling tone for an outside line (refer to Chapter 9). The phone
number then entered is dialled immediately. It is not possible to correct wrong digits
individually, as described above, using this dialling procedure.
76
− Operation −
or
Take the call
End the call
Ringing tone is switched off
Switch to other caller
Enter the phone number (max. 20 digits)
Dial the phone number