Checking The Capacity; Battery Management; Sleep Mode - Derby cycle Impulse Speed 2.0 Originalbetriebsanleitung

b) Seat tube battery: Press the push button briely. The
LEDs light up and display the current battery charge state.
SEAT TUBE BATTERY DISPLAY
•••••
5 LEDs light up
••••
4 LEDs light up
•••
3 LEDs light up
••
2 LEDs light up
•
1 LED lights up
1 LED lashes
5 LEDs lash quickly
1st LED lashes quickly
* All 5 LEDs lash quickly: The battery is a) empty and is
being switched of, or is b) overloaded.
a) If the battery is overloaded, it will switch back on ater
a short idle period and can then be used normally.
b) If the battery is empty, it will work again briely fol-
lowing a short period of rejuvenation and will then
switch back of. It must now be charged.
** The 1st LED lashes quickly to indicate a charging fault.
Please take the battery to your specialist cycle shop.

5.2.2 Checking the capacity

a) Down tube battery: If you hold down the battery button
for roughly ive seconds, the LEDs show the current bat-
tery capacity.
DOWN TUBE BATTERY DISPLAY
••••
4 LEDs light up
•••
3 LEDs light up
••
2 LEDs light up
•
1 LED lights up
1 LED lashes
b) Seat tube battery: If you press the push button for ive
seconds, the LEDs show the current capacity of the bat-
tery.
BATTERY CHARGE
STATE
100-84%
83-68%
67-51%
50-34%
33-17%
16-0%
0% or overloaded *
Charging fault **
CAPACITY
approx. 81–100%
approx. 61–80%
approx. 41–60%
approx. 21–40%
approx. 0–20%
SEAT TUBE BATTERY DISPLAY
•••••
5 LEDs light up
••••
4 LEDs light up
•••
3 LEDs light up
••
2 LEDs light up
•
1 LED lights up
1 LED lashes
The range of the battery is less in winter due to
the lower temperatures. Only move the battery
(rom the warm room where you store it) and it it
on your Pedelec just before you set of. This will
help to prevent the efect of the low temperature
on the range of the battery.
ranty and service life".
5.3

Battery management

The battery management monitors the temperature of
your battery and warns you of incorrect use.
If an external short-circuit has been caused at the
contacts or the charging socket, please consult
your specialist cycle shop.
Never leave the battery unattended during charg-
ing. Disconnect the charger ater use.

5.3.1 Sleep mode

The battery management switches the battery to sleep
mode to prevent a so-called deep discharge. At the latest,
the battery management activates the sleep mode ater
ten days without use. The system exits sleep mode when
you connect the battery to the charger or press the battery
button or push button on the battery. This "wakes up" the
battery.
Original User Manual | Pedelec Impulse Speed 2.0
CAPACITY
100-97%
96-80%
79-60%
59-40%
39-20%
< 20%
Chapter 5.4 "War-
¡
15