Technical Data; Inserting And Removing The Battery - Derby cycle Kalkhoff Bedienungsanleitung

26 | English

Technical Data

Drive Unit
Article number
Rated continuous
output
Output torque, max.
Rated voltage
Operating
temperature
Storage temperature
Degree of protection
Weight, approx.
Drive HMI
Article number
Operating
temperature
Storage temperature
Degree of protection
Weight, approx.
Lighting*
Rated voltage
Power output
– Front light
– Rear light
* Not possible via the eBike battery in all country-spe-
cific versions, depending on the statutory regulations
0 276 001 XXX | (17.1.11)
Drive Unit
0 275 007 000/
0 275 007 001
W 250
Nm 50
V= 36
°C –5...+40
°C –10...+50
IP 5K4K (pro-
tected against
dust and
splash water)
kg 4
HMI
1 270 020 900
°C –5...+40
°C –10...+50
IP 5K4K (pro-
tected against
dust and
splash water)
kg 0.15
V= 6
W 2.4
W 0.6
Assembly

Inserting and Removing the Battery

For inserting and removing the battery in/from
the the eBike, please read and observe the bat-
tery operating instructions.
Inserting and Removing the Drive HMI
(see figure A)
To insert the drive HMI, place it turned by ap-
prox. 30° onto holder 2 and then turn it clock-
wise to the stop.
To remove the drive HMI, turn it approx. 30° an-
ticlockwise and pull it out of the holder 2.
Remove the drive HMI when parking the
eBike, so that the drive cannot be used by
unauthorised persons. Without the drive
HMI, the drive cannot be switched on.
Checking the Speed Sensor
(see figure B)
The speed sensor 9 and its spoke magnet 10
must be mounted in such a manner that the
spoke magnet, after a turn of the wheel, moves
past the speed sensor with a clearance of no
more than 17 mm, max.
Note: If the clearance between speed sensor 9
and spoke magnet 10 is too large or if the speed
sensor 9 is not properly connected, the speed
indication a will fail, and the eBike drive will op-
erate in emergency mode.
In this case, loosen the screw of the spoke mag-
net 10 and fasten the spoke magnet to the
spoke in such a manner that it runs past the
speed sensor with the lowest clearance possi-
ble. When the speed is still not being indicated
in the speed indication a after this, please refer
to an authorised bicycle dealer.
Bosch ebike Systems