Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Special informations on the shredding procedure:
Branches, twigs and wood should be broken down
immediately after they have been cut
material of this kinds gets very hard when it is dry, and it
−
therefore makers sense to reduce the maximum branch
diameters, so that it is ready for shredding.
Remove any side shoots from branches with a large
number of twigs.
How to shred garden and kitchen waste with hight water
content and a tendency to clog
to prevent the machine from clogging, alternate waste
−
with wood containing material.
Do not allow the shredded material to pile up too high in the
area of the ejection opening. This can lead to shredded
material blocking the ejection channel, and backing up to the
filler opening.
Clean out the filler opening and ejection channel thoroughly if
the machine becomes blocked. Before doing this, switch the
motor off and disconnect the machine from the mains power
supply.
Please do not exceed the maximum branch diameter
specified for your appliance (∅ see p. 15).
The blades largely pull the material into the machine by
themselves.
Strong branches may cause overloading. This can be
avoided by pulling them back from time to time.
If the machine is overloaded, a protective motor switch
ensures that the machine turns itself off automatically
turn the shredder on again after about 5 minutes
−
during those five minutes you cannot turn the machine,
−
see point „Operational faults".
C
h
a
n
g
i
n
C
h
a
n
g
i
n
Remove the mains plug before changing the
blades.
Risk of injury to the fingers and hands when carrying out
work on the blade unit. Wear protective gloves.
Fix the blade.
Reduced output
One edge of the knife has become blunt
Turn knife so that you can use the other edge
g
t
h
e
b
l
a
d
e
s
g
t
h
e
b
l
a
d
e
s
Left-hand
thread
Both edge of the knives have become blunt
replace with sew set of knives (order-no. 384547)
Take care when maintaining the cutting equipment to ensure
that the cutters can still be operated by the starter
mechanism, even if the motor is not running because the
cover has been unlocked.
Wear protective gloves.
Generally garden shredders require little maintenance.
To maintain their efficiency and a long life, observe
the following:
•
After shredding, the machine must be cleaned inside
and outside
•
Slightly grease polished metal components immediatley
after use (to prevent rusting)
Please refer to the drawing and list for spare.
Ordering spare parts:
Available from the manufacturer
−
PZ 3
Orders must quote the following inforation:
−
• Colour of appliance (for housing parts)
• Spare parts no.
• Quantity required
• Shredder model
• Name of the garden shredder
Example: orange, 382062, 1, BioPlus 2450, AH 402
14
M
a
i
n
t
e
n
a
n
c
e
a
n
d
M
a
i
n
t
e
n
a
n
c
e
a
n
d
Remove the mains plug before maintenance
and care.
S
p
a
r
e
p
a
r
t
s
S
p
a
r
e
p
a
r
t
s
C
a
r
e
C
a
r
e
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
