Starting The Main Station / Changing Batteries - Auriol 304126 Bedienungs- Und Sicherheitshinweise

Starting the main station / changing batteries

Open the battery cover at the back of the main station by
5
pulling up on the tab at the bottom of the battery compartment.
When changing batteries first remove the old batteries.
Insert the new batteries, type LR06, in the battery compartment .
16
Check the polarity of the battery during insertion. This is indicated
in the battery compartment.
Close the battery cover.
The display will briefly light up and run a brief check of all
1
display elements.
Plug the low voltage plug of the mains adapter into the mains
30
adapter socket in the main station and plug the mains adapter
31
into an easily accessible outlet. The display will permanently light
up and run a brief check of all display elements.
Note: Batteries power supply only for data backup only. When
you unplug the mains adaptor , the storage setting value will
30
not be delete.
The outdoor temperature field will show an animation of the
23
reception symbol , indicating the main station is searching for
the signal from the outdoor sensor.
If no outdoor temperature is displayed after 3 minutes,the main
station will stop searching. The animation of the reception symbol
will turn off and the outdoor temperature field will show --._ °C and
--._ %. Most likely, the signal cannot be received due to structural
factors, reinforced concrete walls, the brickwork being too solid,
or the distance between the units. After finding a better location for
the outdoor sensor, reception will need to be restarted.
Press and hold the CH button at the back of the main station
15
for 3 seconds until the reception signal becomes animated again.
The product will automatically start receiving the outdoor sensor
signal, regardless if signal from the outdoor sensor was received
or not. The clock field will show an animated radio tower
24
GB 13