Bemer PRO SET Handbuch Seite 133

error message cause
ERROR 1 An active applicator has been removed during the application.
ERROR 2 The temperature of the device is too high.
ERROR 3-4 There is a problem with the application module.
ERROR 5-6 There is a malfunction of the power supply.
ERROR 7-8 There is a malfunction with the control device.
ERROR 9-12 There is a malfunction of the application module.
ERROR 101 There is no applicator connected.
ERROR 104 An unknown applicator has been detected.
ERROR 105 The capacity of the battery is too low.
magyar magyar français français
troubleshooting
Reconnect the applicator and start the application again.
Check the environmental conditions and let the device cool down.
When in doubt, contact service.
Please contact service.
Please check for the possible sources of error such as:
the power supply / the vehicle connection cable (12 volt) or the rechargeable
battery (see technical data). When in doubt, contact service.
Please contact service.
Please contact service.
Please connect an applicator to the device.
The applicator module is invalid, please contact service.
The battery is empty, recharge the battery by connecting
to the power supply.
english deutsch
eNGLIsh deutsch
133