Troubleshooting - Bemer PRO SET Handbuch

Troubleshooting

General information
BEMER devices are equipped with intelligent elec-
tronics. Therefore they can automatically detect and
display errors. Should an error be displayed or should
you suspect malfunction, then check the following:
>> Is the electricity connected to the power supply
(does the power supply have a corresponding
control light)? If not, then connect the electricity
to the power supply.
>> I s the power supply connected to the B.BOX?
If not, then connect the electricity to the
power supply.
>> A re the desired application modules
properly connected?
>> A re all the cables and plugs that come
into question undamaged?
132
: : troubleshooting
If an error still persists or if one has not been properly located,
please follow the instructions of the corresponding error code
or contact your responsible service address. When in doubt, you
can get information at www.bemergroup.com, where you will
find your next closest contact person.
switching off the error message
When the error or cause has been remedied, you can switch off
the error message on the device again. This procedure using the
B.BOX Pro is self explanatory and is found in the menu navigation.
The error message on the B.BOX Classic is shut off by pressing the
button "Set".