Addressing; Connection With The Mains; Operation - EuroLite CRT-120 Bedienungsanleitung

Addressing

Each device occupies 8 channels. To ensure that the control signals are properly directed to each device,
the device requires addressing. This is to be adjusted for every single device by changing the starting
address via the control board.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more devices are addressed
similarly, they will work similarly.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the CRT-120 starts running.
Via the function buttons, you can select the desired mode:
[ALL-] All On: all LEDs are on at the same time
[PU--] Program: selection of the different programs.
[SP--] Speed: the controller runs through the program. The program speed can be adjusted fro 1 to 20.
[Addr] DMX: adjustment of the DMX-address between 1 and 512. The LED curtain is controlled via the
connected DMX-controller.
[Soud] Sound Control: the controller runs sound-controlled through different programs.
Selection of the different programs
RGBY-version
Program 1 color shade and change
Program 2 all LEDs shade
Program 3 color change
Program 4 strobe and change
Program 5 all LEDs change
Program 6 Red color on
Program 7 Green color on
Program 8 Blue color on
Program 9 Yellow color on
Program 10 Red + green color on
Program 11 Red + blue color on
Program 12 Green + blue color on
Program 13 Red and yellow color on
Program 14 Red color strobe
Program 15 Green color strobe
Program 16 Blue color strobe
Program 17 Yellow color strobe
International
L
N
White LED version
color shade and change
all LEDs shade
color change
strobe and change
all LEDs shade
one color on
one color on
one color on
one color on
two loops white color on
two loops white color on
two loops white color on
two loops white color on
white color strobe
white color strobe
white color strobe
white color strobe
21/23 00055335.DOC, Version 1.3