Replacing The Fuse; Replacing The Leds; Technical Specifications - EuroLite CRT-120 Bedienungsanleitung

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

Replacing the LEDs

Compared to incandescent lamps, LEDs have a very long life and usually no replacement is required.
However, just in case there is a defect, a few spare LED modules are supplied.
1) Separate the cable connection between the LED curtain and the controller.
2) Open the zip fastener at the side of the LED curtain; the connections of the LED modules will be
accessible.
3) Before disconnecting the plugs from the defective module, note the polarity (small marks "+" and "-" on the
PCB). If necessary, remove the retaining adhesive at the connectors in order to disconnect the plugs.
4) Connect the spare module using the same polarity.
5) From the front of the cloth, pull the black plastic ring around the LED from the PCB of the defective
module and remove the module.
6) Insert the LED of the spare module from the rear through the hole in the cloth and, from the front, insert a
black plastic ring through the cloth so that the two pins will engage in the corresponding holes provided on
the PCB.
7) After replacing the necessary modules, close the zip fastener again.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
DMX control channels:
DMX512 connection:
Curtain connection:
Number of LEDs:
LED type:
Sound-control:
Flash rate:
Curtain dimensions (WxH):
Curtain weight:
Controller dimensions (LxWxH):
Controller weight:
Maximum ambient temperature t
Maximum housing temperature t
Min. distance from flammable surfaces:
Min. distance to lighted object:
Fuse:
Accessory:
EUROLITE Show stand I Alu
Tyrap 350x4,8mm black
Safety bond 3x600mm up to 5kg, black
Please note: Every information is subject to change without prior notice. 17.02.2011 ©
100-240 V AC, 50/60 Hz ~
15 W
8
3-pin XLR
5-pin DIN
120
5 mm
via built-in microphone
1-12 Hz
3 x 2 m
3.6 kg
220 x 125 x 65 mm
1 kg
: 45° C
a
(steady state): 60° C
C
0.5 m
0.1 m
F 2 A, 250 V
No. 59007010
(100pcs) No. 30006080
No. 58010342
23/23 00055335.DOC, Version 1.3