Inhaltsverzeichnis
Werbung
Modellbau
Press [SEL] to check Cycle data .
Note: The cut-off voltage is the same as in normal discharge mode.
Quickly press the [ENT] button. The discharge current and discharge cut-off voltage will flash. Press[INC]or[DEC]to
change values while flashing.
Press the[ENT]button for 2 seconds to initiate discharging.
Check Output battery connection.
Check the input voltage. The input voltage of the power supply is too high or too low
Check battery connector polarity.
Check Balancer adaptor connector .
Check the set number of cells and check the balancer connection.
Check whether the battery type setting is correct or not, and connect the balancer adaptor to the battery.
Increase system time .
Check battery pack voltage. The pack may have one or more cells over charged
www.lindinger.at
+
14
Produkt ist kein Spielzeug, nur unter unmittelbarer Aufsicht von Erwachse-
nen betreiben.
This product is not a toy. Operate only under the direct supervision of adults
© Copyright by Modellbau Lindinger GmbH - jede Veröffentlichung, Weitergabe oder kommerzielle Verwendung
Modellbau Lindinger GmbH
Single booster
Bedienungsanleitung Deutsch
Modellbau
bedarf unserer schriftlichen Genehmigung.
28
6 Li ad/dc 12/220v
Modellbau Lindinger GmbH
Industriestrasse 10
4565 Inzersdorf im Kremstal
AUSTRIA
Tel: +43-(0)7582-81313-0
Fax: +43-(0)7582-81313-17
e-mail: office@lindinger.at
Made in China
B-Nr.: 88309
www.lindinger.at
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
