Recycling - Lindinger SINGLE BOOSTER Bedienungsanleitung

Modellbau
1. SAFETY PRECAUTIONS
1a. LiPo BATTERIES
Lithium polymer, LiFe and lithium batteries in general require a particular attentive treatment. This
applies to charging, unloading, storage and other handling. Please pay special attention to the following
instructions please make sure to keep this manual always at hand. Improper treatment can lead to
explosions, fires, smoke development and poisonous danger. Neglecting the following safety and warning
rules will also lead to a reduced battery performance.
Cells with different capacities may not be connected in parallel or series, because the cell characteristics
are too different. If however you connect LiPo batteries in parallel or series, BMI refuses all warranty claims
or damages that result from this operation. BMI-supplied LiPo batteries are therefore selected.
CHARGE
- Put the battery on a not inflammable, heatproof and not conducting underground during the charging
process.
- Never charge the battery while it is situated in your model, and never charge it in the neighbourhood of
inflammable or easily inflammable products.
- Always charge the batteries under supervision.
- Only use chargers that are capable of charging LiPo batteries.
- Never charge the battery in a vehicle.
- Should the battery become too warm, remove and disconnect it immediately from the charger.
- Charge the cells with max. 1C (value of 1C = cell capacity) charging current.
STORAGE
- LiPo cells are to be stored with a charged capacity of 50% (3.85V per cell). If you don't charge them
partly charged, they will become useless. Do not discharge the battery too low because it will be defective.
Only use your model for 10-12 minutes.
- LiPo cells are more fragile then batteries in metal housings. Make sure to avoid shocks. If the battery
suffers a shock or the model has Beep inflicted in a crash remove the battery from the model. Leave it for
at least 30 minute on a not inflammable and heatproof underground.
- Every contact with any kind of liquid is to be avoided.
- Never take a LiPo battery pack apart.

RECYCLING

- If a LiPo battery gets damaged (punctured casing, ...) please follow the next procedure :
Discharge battery – Cool down battery – Emerge battery for several hours in a salted water bath - - Hand
over battery to a certified battery recycling center.
- Since BMI NV/SA cannot supervise the correct charge, unloading and storage, any warranty resulting
from incorrect charge, unloading or storage is excluded. BMI refuses all possible warranty claims and/or
damage claim caused by use of these batteries.
1b. Warnings
- Never leave the charge unsupervised when it is connected its power supply. If any malfunction is
observed immediately terminate the process and refer to the operation manual.
- Keep away the unit from dust, damp, rain, heat direct sunshine and vibration. Do not drop it.
- This unit and the battery to charge or discharge should be set up on a heat resistant, non-inflammable
and non-conductive surface. Never place them on a car seat, carpet or similar. Keep all the inflammable
Modellbau Lindinger GmbH
Single booster
Manual English
22
6 Li ad/dc 12/220v
B-Nr.: 88309
www.lindinger.at