Warranty And Liability; Maintenance, Care, Storage And Transport - Goobay EasySlide S Betriebsanleitung

Fig. 32: Managing the cables
End of installing. To remove, proceed in reversed order.
5

Warranty and liability

• T he producer grants a 2 years warranty to a new device.
• As the manufacturer has no influence on installation, warranty only applies
to the product itself.
• If any fault or damage is detected on your device, please contact your dealer
and provide your sales slip or invoice as evidence of the purchase, if
necessary. Your dealer will repair the fault either on site, or send the device
to the manufacturer. You make the work of our technicians considerably
easier, describing possible faults in detail – only then you can be assured
that faults, occurring only rarely, will be found and repaired with certainty!
• The manufacturer is not liable for damages to persons or property caused by
improper installation, operation or maintenance, not described in the manual.
• Do not alter or modify the product or its accessories.
• Any use other than described in this user`s manual is not permitted and
causes loss of warranty, loss of guarantee, and non-liability.
• We reserve our right for misprints and changes of the device, packing, or
user`s manual.
6 Maintenance, Care, Storage and Transport
• The product must be maintained only by professional workshops.
• Protect the angles from dirt and grease them regularly with light machine oil.
• Use a dry and soft cloth to clean your product. Be careful to avoid scratches.
Use a slightly moist cloth for heavy stains. Look out for live cables! Do not
use any cleaning supplies. This can cause burns to the materials. Avoid
liquid entry to the device.
• Make sure no body parts will be pinched in the swivel device, when parts of
the device are moved!
• Periodically check, if all attachments and screws are secured, and tighten
them again when they are loosened. This may be caused e.g. by frequent
movements. Do not overtighten screws.
• Avoid places with high temperatures, humidity, or places which can become
1. Connect sufficiently long
cables.
2. Press them into the cable
holder(s).
Make sure leaving enough slack
around the cables, to ensure mobility
of the system.
33