Operation - Cameo TS 100 WW Bedienungsanleitung

8
ZOOM
Knurled knob for adjustment of beam size (Fully clockwise = minimum beam size, fully counterclockwise = maximum beam size).
9
SECURING LUG
Overhead installation must only be carried out by qualified personnel. The spotlight must be fitted with a suitable safety rope to ensure that
it does not fall down.

OPERATION

PLEASE NOTE:
When the spotlight is connected to the mains, during the startup process, different information will appear in the display: "Update Wait..."
(only for service purposes), "WELCOME TO CAMEO", and the software version. After this process, the spotlight is ready for operation and the
previously selected mode will be activated.
MAIN DISPLAY DMX MODE
"DMX Addr" is displayed in the top line of the display and the currently configured DMX start address is displayed in the bottom line. If the
DMX signal is interrupted, the display will begin to flash. It will stop flashing once the DMX signal is restored. The main display is activated
automatically if no input is made within approximately 30 seconds.
DMX Addr
001
MAIN DISPLAY STANDALONE MODE
The currently activated standalone mode (slave, static) is shown in the bottom line of the display. The main display is activated automatically if
no input is made within approximately 30 seconds.
Slave Static
6
9
8