Connections, Operating And Display Elements; Control Buttons - Cameo TS 100 WW Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

7
MENU
TS 200 WW
7
ENTER
1 POWER IN
Blue Power Twist mains socket. Operating voltage 100-240 V AC/50-60Hz.
2
POWER OUT
White Power Twist mains socket for the power supply of additional CAMEO spotlights. Ensure that the total current consumption of all
connected devices does not exceed the value specified on the device in amperes (A).
3 FUSE
Fuse holder for 5 x 20mm microfuses. IMPORTANT: Replace the fuse only with a fuse of the same type and value (TS100WW: T2A/250V,
TS200WW: T3A/250V). In the event of repeated fuse failure, please contact an authorised service centre.
4 DMX IN
Male 3-pin or 5-pin XLR socket for connection to a DMX control device (e.g. DMX console).
5
DMX OUT
Female 3-pin or 5-pin XLR socket for sending the DMX control signal.
6
ILLUMINATED LC DISPLAY
Displays currently active mode and the menu items in the Edit menu.
7

CONTROL BUTTONS

MENU – Press MENU to access the selection menu for system settings. Press repeatedly to go back to the main display.
ENTER – Press ENTER to change a value and to confirm changes.
UP and DOWN buttons – Press to move through the individual menu items in the selection menu and submenus (mode, system information,
etc.) and to change a value, such as the DMX address.
7
6
UP
7
6
DOWN
4 1 3 2
POWER IN
3
1
4 5
FUSE:
T3A / 250 V
DMX IN DMX OUT
5
POWER OUT
2
5