Sony VPL-FX51 Installationsanleitung Seite 11

5
Disconnect the two connectors on the lens from
those on the projector.
6
Remove the four screws (M4×12, with washers)
locking the lens by using a Phillips screwdriver.
7
Remove the lens by lifting it slightly, widening the
lens cushion and sliding it forward.
8
Widen the lens cushion and install the lens so that
the lens stopper and the projector stopper meet at
their edges.
Notes
• Be sure not to catch the connectors when
installing the lens.
• For ease of identification when you install the
lens, make sure that the label on the lens is facing
up.
Stopper (Projector)
Stopper (Lens)
9
Tighten the four screws to secure the replacement
lens firmly.
10
Connect the two connectors.
Skip this step and the next when installing a lens
other than the standard one.
11
Fasten the connector cables you released in step 4
with the cable binder.
12
Install the lens cover by sliding it from front to
back.
13
Tighten the two screws to secure the lens cover
firmly.
Notes
• The lens scratches easily, so when handling it,
always place it gently on a stable and level surface in
a horizontal position.
• Avoid touching the lens surface.
Lens cover
11