Counter Function; Automatic Start Function; Stand By; Cleaning - Zummo Z1 Nature Bedienungsanleitung

6.3. COUNTER FUNCTION

The display stores the total number of cycles* completed. To visualize the figure,
 With the machine stopped and in stand-by, press the STOP button
 The figure will appear on the display for a few seconds.
Bear in mind that all machines show a minimum of 100 to 125 cycles completed for quality control
testing.
*(Cycle = complete set of movements to squeeze a piece of fruit)

6.4. AUTOMATIC START FUNCTION

Turn off the machine at the mains.
With the machine turned off, press STOP, keep it pressed and turn the machine on at the mains; keep
it pressed for 4 seconds and the display will show four numbers.
When you have reached this point, look for the number 4104; by pressing ON you control the two digits
on the left and by pressing SELECT you control the two digits on the right; then press STOP (when
you press STOP the display will show ----) and then turn off the machine at the mains (if the machine
is not switched off, it cannot leave this screen display).
When you turn on the machine again (first you see the programme version and then the number 4104),
it will start operating when the photocell detects oranges and will continue operating until the oranges
are finished or you press STOP.

If it stops when the oranges have finished, you simply need to put more oranges on the ramp
to put the machine back into operation.

If you press STOP, the machine will stop and the oranges will remain on the ramp. To turn the
machine back on again:
- Remove the oranges on the ramp and then put them back again or press ON.
Important: keep the lens of the photocell clean to ensure it can visualize the fruit properly (Fig.8).
TO RETURN TO THE STANDARD OPERATING SYSTEM.
Repeat the process by entering code 1001.

6.5. STAND BY

The machine has a stand-by power-saving system which is activated automatically after 5 minutes.
When the machine is on stand-by, the display light goes out and all the icons except the one for the
machine are disabled.
To exit this situation, press any of the three buttons on the plate.

6.6. CLEANING

The machine squeezing area and parts must be cleaned daily.

If the machine is in operation, always stop it using the Programmer button STOP. Never attempt to
stop the machine using the mains switch. Failure to follow this recommendation will cause the
machine to stop in a position that impedes cleaning; possibly leading to breakage of parts due to
poor handling.

Disconnect the machine using the power switch (Fig. 9).
27