Floating Magnets - Balluff BTL6-U110-M0500-PF-S4 Betriebsanleitung

BTL6-U110-M _ _ _ _ -PF-S4
Micropulse Transducer in a Flat Profile Housing
4
Installation and connection (continued)
4.3

Floating magnets

The following must be observed when installing the
magnet:
– To ensure the accuracy of the position measuring
system, the magnet is attached to the moving member
of the machine using non-magnetizable screws
(stainless steel, brass, aluminum).
– The moving member must guide the magnet on a track
parallel to the transducer.
– Ensure that the distance A between parts made of
magnetizable material and the magnet is at least
10 mm (see Figures 4-3 to 4-7).
– Maintain the following values for distance B between
the magnet and transducer and for center offset C
(see Figures 4-3 to 4-7):
Type of magnet
BTL5-P-3800-2
BTL5-P-5500-2
BTL5-P-4500-1
BTL6-A-3800-2
BTL6-A-3801-2
The selected distance should stay constant over the entire measuring
1)
length.
For optimum measurement results, a distance B of 6 to 8 mm is
2)
recommended.
Tab. 4-1: Distance and offset for magnets (see Figures 4-3 to 4-7)
A A
Fig. 4-3: Dimensions and distances with BTL5-P-3800-2 magnet
A A
Fig. 4-4: Dimensions and distances with BTL5-P-5500-2 magnet
www.balluff.com
Distance B Offset C
1)
0.1 to 4 mm ± 2 mm
5 to 15 mm ± 15 mm
0.1 to 2 mm ± 2 mm
4 to 8 mm ± 2 mm
2)
4 to 8 mm ± 2 mm
2)
C
C
A A
Fig. 4-5: Dimensions and distances with BTL6-A-3800-2 magnet
A A
Fig. 4-6: Dimensions and distances with BTL6-A-3801-2 magnet
Plug with
A A
LED
4
Fig. 4-7: Dimensions and distances with BTL5-P-4500-1
electromagnet (24 V/100 mA)
The measuring range is offset by 4 mm towards
the BTL plug (see Figure 4-7).
C
C
C
english 9