Device Specification; Process Data - Balluff BTL6-U110-M0500-PF-S4 Betriebsanleitung

BTL6-U110-M _ _ _ _ -PF-S4
Micropulse Transducer in a Flat Profile Housing
6
IO-Link interface (continued)
6.2

Device specification

Specification
Transfer rate
Minimum cycle time of device
Frame specification
- Amount of preoperate data required
- Amount of operate data required
- Enhanced parameters
IO-Link protocol version
Amount of process data from the
device to the master
Amount of process data from the
master to the device
Manufacturer ID
Device identification
Tab. 6-1: Device specification
Transfer times
Process data cycle with 1.0 master
Process data cycle with 1.1 master
Tab. 6-2: Device transfer times
6.3

Process data

The BTL6-U110-... transducer outputs a signed integer
value (32 bits) via the IO-Link interface. This integer value is
a relative specification of the factory default null point. The
specification resolution is 1 µm/digit.
The measurement resolution of the
BTL6-U110-... transducer is 5 µm. Intermediate
values are not displayed in the output value.
The factory default null value can be shifted within the
measuring range via the parameter "Null point offset."
The value "0" specifies the position of the magnet
(see parameter data on page 14).
In the case of an error, if no magnet can be detected, the
maximum value 0x7FFFFFFF or 2147483647 is output as
an error value. Additionally, the data is labeled as invalid.
www.balluff.com
IO-Link Description
COM3
min cycle time
M-sequence capability:
- Preoperate M-sequence type
- Operate M-sequence type
- ISDU supported
Revision ID
ProcessDataIn
ProcessDataIn
Vendor ID
Device ID
Number of PD x master cycle time = 4 x 1 ms = 4 ms
master cycle time = 1 ms
Value
230.4 kBaud
0x0A (1ms)
0x1B
2 bytes
2 bytes
supported
0x11 (Version 1.1)
0x83 (4 bytes)
0x00 (0 bits)
0x378
0x030101
english 13