Replacing The Battery - Cola TERMOFIRE L Anleitung

MENU 03 – Set chrono
Allows all time programming functions to be enabled/disabled. To enable the chrono, access the first submenu
ENABLE CHRONO and set it to ON with buttons P1 or P2. The manual commands from the emergency panel or
remote control have priority over programming. The stove is equipped with three different types of programming:
daily, weekly and weekend. Chrono enabling is signaled by the LEDs shown in the picture below. Daily, weekly and
weekend programming is active only if the general chrono is enabled.
Access the second submenu DAY PROGRAM to enable or disable daily programming with buttons P1 and P2.
Then press button P7 and then buttons P1 and P2 to set up to two operation phases delimited by the set times.
Access the second submenu WEEK PROGRAM to enable, disable and set the weekly programming functions.
Follow the same procedures of the previous paragraph. Up to four operation phases delimited by the set times and
days can be set.
Carry out programming making sure not to overlap the hours of activation and/or deactivation on the same
day in different programs.
Access the third submenu WEEKEND PROGRAM to enable, disable and set the weekly programming functions for
the weekend. Follow the same procedures of the previous paragraph. Up to two operation phases delimited by the
times can be set.
To avoid unwanted startup and shutdown operations, activate only one program at a time.
MENU 04 – Select language
With this selection it is possible to set the desired language from those available.
MENU 05 – Standby mode
By selecting ON in STANDBY mode the corresponding symbol on the display lights up and the stove shuts down
automatically when the room temperature T has reached the set value (Tset + ΔT) for a given time.
The next restart in automatic will be possible only when the room temperature falls below the set value by a few
degrees and precisely (Tset - ΔT) where ΔT default = 2°C.
With the OFF selection, the modulation function is active but not the STANDBY mode. Therefore when the
temperature exceeds the set value the stove will operate at minimum power.
MENU 06 – Buzzer mode
With this selection it is possible to activate or deactivate the stove acoustic signals for alarms.
MENU 07 – Initial load
Allows the preloading of pellets for a given time. This function can only be activated when the stove is off and is
used if the auger is empty due to no more pellets. It is started with button P1 and stops with button P3.
MENU 08 – Stove/stove status
This selection is reserved for the COLA service center authorized technician.
MENU 09 – Technician settings
This selection is reserved for the COLA service center authorized technician.
Modification of the technical parameters of menu 09 must be done by authorized and competent
personnel; any random changes made can cause serious damage for which COLA declines any liability.
MENU 10 – Installer settings
This selection is reserved for the qualified installer and/or COLA service center authorized technician.
4.2.5

Replacing the battery

The remote control is powered by tre batteries located in the back of the device. For insertion and possible
replacement, proceed as follows:
- Open the cover on the back of the remote control;
- Replace the AAA 1.5 V batteries, respecting thepolarity;
- Close the remote control
- Keep the remote control away from direct heat sources and water.
- The battery of the remote control must be replaced and disposed of in a safe way
respecting the local regulations
Cover
52 TERMOFIRE L