Cola TERMOFIRE L Anleitung Seite 59

- Occurs when the water
FROST RISK
temperature falls below a certain
value.
Occurs when the stove has
SERVICE
exceeded 1800 hours of
operation or 2000 Kg pellet,
DUE
since the previous servicing
8 MENù INSTALLER SETTINGS
The following instructions are reserved for technical personnel with specific expertise regarding Cola units.
Changing the parameters in a non-appropriate way can cause serious damage to people, the units and the
environment. In this case, Cola s.r.l. declines any liability.
To access the INSTALLER SETTINGS menu press the MENU button and use the scroll buttons to display the item
INSTALLER SETTINGS and then press the MENU button.
Use the scroll buttons to display access key 10 and press the MENU button. The various parameters can be
displayed with the scroll buttons; access with the MENU button, edit them with the scroll buttons and exit with ESC.
It contains the adjustment parameters given below.
Parameter code
10-01
10-02
10-03
10-04
10-05
10-06
10-07
The Manufacturer reserves the right to make technical or aesthetic changes to the products at any time without notice.
The drawings, measurements, diagrams and any other configurations are given only by way of example.
-The stove control detects the
water temperature below 6°C
and displays a message.
-Extraordinary
notice.
For increasing or decreasing auger OFF duration.
For increasing or decreasing fume extractor speed for all powers, by a
value of 5% for each unit.
Enable keylock.
Adjustment probe temperature setting ON/OFF delta (see parameter
10-07)
Stove shutdown delay with room temp. met. Valid only in case of
Standby set to ON.
For enabling self-calibration.
For selecting the probe on which stove adjustment is to be set:
-LOCAL PROBE: probe on stove and connected to the motherboard.
-RADIO PROBE: probe located on the remote control.
"management and coordination of Ferroli SpA"
maintenance
Description
59
-The pump starts in order to move
the water inside the heating
circuit.
- Monitor the water temperature
so that it does not fall below 0°C.
- Cleaning - extraordinary
maintenance and reinstatement
operations must be carried out by
a service centre.
TERMOFIRE L