Replacing The Battery - Cola CHARME CANALIZZABILE Installations-, Bedienungs- Und Wartungsanleitung

MENU 04 – Select language
With this selection it is possible to set the desired language from those available.
MENU 05 – Standby mode
By selecting ON in STANDBY mode the insert shuts down automatically after the room temperature has remained
above the SET value for a fixed time.
The next automatic relighting will be possible only when the room temperature falls below the set value entered in
the parameters table (default 2°C).
By selecting OFF the insert activates the modulation function but not the STANDBY mode. Therefore when the
temperature exceeds the set value, the insert operates at minimum power.
MENU 06 – Buzzer mode
With this selection it is possible to activate or deactivate the insert acoustic signals for alarms and for pressing
buttons on the remote control.
MENU 07 – Initial load
Allows the preloading of pellets for a given time. This function can only be activated when the insert is off and is
used if the auger is empty due to no more pellets. It is started with button P1 and stops with button P3.
MENU 08 – Stove/insert status
This selection is reserved for the COLA service center authorized technician.
MENU 09 – Technician settings
This selection is reserved for the COLA service center authorized technician.
Modification of the technical parameters of menu 09 must be done by authorized and competent
personnel; any random changes made can cause serious damage for which COLA declines any liability.
MENU 10 – Installer settings
This selection is reserved for the qualified installer and/or COLA service center authorized technician.
MENU 11 – ECO mode
Selecting ON in ECO mode limits insert operation to modulation, i.e. at minimum power. The display shows the
message ECO MOD.
4.2.5

Replacing the battery

The remote control is powered by two batteries located in the back of the device. For insertion and possible
replacement, proceed as follows:
- Open the cover on the back of the remote control;
- Replace the AAA 1.5 V batteries, respecting the
polarity;
- Close the remote control
- Keep the remote control away from direct heat sources and water.
- The battery of the remote control must be replaced and disposed of in a safe way,
respecting the local regulations;
4.3 Use via control panel
To access the panel, remove the protection profile in the bottom of the insert.
Press button P3 on the control panel for a few seconds to turn the insert on and off. Use buttons P1 and P2 to set
the maximum power, indicated by the LED of button P2. Then the medium power equal to power 3, indicated by
lighting up of the LED of buttons P1 and P2, and lastly the minimum power, indicated by the LED of button P1.
It is not possible to set the temperature, the intermediate operating powers or access the various menus with the
emergency panel.
Cover
48 CHARME CANALIZZABILE