Set And Change 'End' Systems (Radio Frequency) - Goelst G-Rail 6200 Serie Gebrauchsanweisung

5
Connecting multiple systems

Set and change 'end' systems (Radio frequency)

RF
22
STEP 1
1 2
Aim: Prepare the motor-unit to set/delete as an 'end' motor
Method: Disconnect the motor-unit from the BUS, the
round 24V plug must remain in place: remove all other
RJ45 plugs from the underside of the motor-unit and
place an RF receiver in port 2 (black) on the underside of
the motor-unit).
STEP 2
Aim: Enter programming mode
Method: Press the STOP button until the LED on the
underside of the motor-unit flashes alternating green/red
after 20 sec. (!) and release the button. Now press the
OPEN button to program the motor as an 'end' motor ( ).
The LED will light up green for 2 sec.
[The 'end' motor setting is deleted by pressing the
CLOSE button; the LED will light up red for 2 sec.]
STEP 3
Aim: confirm programming
Method: If the end motor has been set (or deleted), briefly
press the STOP button to confirm. The LED goes out.
Remove the 24V plug and insert it again to activate the
resistor.
Repeat steps 1, 2 and 3 for the other 'end' motor.
Finally, reconnect the BUS cables.