Adding/Removing Curtain Positions; Changing Button Functions For Opening And Closing - Goelst G-Rail 6200 Serie Gebrauchsanweisung

3
Setting curtain positions
STEP 5
Aim:
Method:
STEP 6
Aim:
Method:
See:
The positions have been adjusted and the rail is ready for use. See chapter 4 for
function options.
− In the event of a power cut, the position settings in the motor-unit will be maintained.
− If the system/curtain is moved without power being supplied (i.e. during a power cut), it will
!
lose its reference positions and they will have to be re-entered.

Adding/removing curtain positions

In order to change or add curtain positions in a system, you must repeat the above steps 1 to 6
of "setting curtain positions" for that system.

Changing button functions for opening and closing

Repeat the procedure for "Setting curtain positions with the 2-button switch or buttons on
underside of the motor-unit", selecting the switch buttons in reverse order.
For several linked systems:
Remember that changing the "open" and "close" positions will have consequences for any
!
central control of linked systems; for example, a central "close" command will result in the
system being opened.
14
Set the "Curtain open" position.
Now press the other button and keep it pressed until the curtain
reaches the desired "open" position.
Fine tune and confirm the "Curtain open" position.
Use the two buttons to adjust the curtain postion as desired, then
briefly press both buttons at the same time to confirm the posi-
tion.
The system will move a short distance, in close direction, and the
red LED underneath the motor-unit will go out.