Preparing A Stand-Alone Motor-Unit; Preparing A Tandem System - Goelst G-Rail 6200 Serie Gebrauchsanweisung

Preparing a stand-alone motor-unit

First connect the infrared receiver or switch and then the 24V-power supply to the underside of
the motor-unit.
24V DC power supply
When using infrared control, please refer to the separate manual for infrared.
!
When using RF control from Nice, please refer to the separate manual for the Nice RF.

Preparing a Tandem system

With a tandem system, make the following connections before going through chapter 3. Connect
the power supply last.
Control: on the first or second motor
Connection cable: on the first and second motor, (type A, see chapter B4)
Power supply 24V DC (6230-1000): on the first and second motor
Control
Preparation
switch
6048-1001
2
11