Setting Curtain Positions; 6200 & 6200-T; Setting Curtain Positions With The 2-Button Switch Or Buttons On Underside Of The Motor-Unit - Goelst G-Rail 6200 Serie Gebrauchsanweisung

6200 & 6200-T

Setting curtain positions with the 2-button switch or buttons on underside of the motor-unit

1) Provisional end-postions are factory-set at 40 cm running distance.
! 2) If you have IR or RF control, see the IR or RF manual for further control and programming
options.
Programming of the end-positions is now required, i.e. the "Curtain opened" and "Curtain
closed" positions. Only where 'pre-fix "20" or "2T' is shown on the silver motor identification
label can series 6200 or 6200-T be programmed. This must be carried out per system. Once
these start and stop positions have been set, the system will always operate within these two
1) First remove all plugs from the motor-unit on a system already connected. Both motor-units
of a tandem system must be connected. Power must be supplied to the motor by the 24V plug.
!
2) When not being operated, the motor-unit will automatically exit the programming mode
after 1 minute: the LED will go out, return to step 1.
STEP 1
Aim:
Method:
STEP 2
Aim:
1 2
Method:
Note: In the next step, you will decide which of the two buttons will subsequently carry out the
!
"Close" function. This can be changed any time at a later stage.
STEP 3
Aim:
Method:
STEP 4
Aim:
Method:
See:

Setting curtain positions

limits. The end positions can be fine-tuned during programming for
a smooth curtain folding effect.
Prepare the system to determine curtain positions.
Remove all RJ45 plugs from underneath the motor-unit and
connect the switch to a free port 1 or 2. Power must be supplied
to the motor by the 24V plug. Use the switch to ensure a distance
of at least 20 cm between the overlap carrier and the return pulleys.
Enter programming mode.
Press and hold both buttons and release when the
LED on the underside of the motor-unit flashes red
(after ca. 8 sec.); The system will move briefly in
both directions after the switch is released.
Determine the "Curtain closed" position.
Press and hold one of the two buttons and release it when the
curtain has reached the desired position.
Fine tune and confirm the "Curtain closed" position.
Use the two buttons to adjust the curtain postion as desired, then
briefly press both buttons at the same time to confirm the posi-
tion.
The system automatically moves a short distance in the "open" direction.
6200 and 6200-T only
3
13