Preparation; Taking Into Use; Overview Of Components In The Underside Of The Motor-Unit - Goelst G-Rail 6200 Serie Gebrauchsanweisung

Taking into use

The following actions must be carried out in the sequence stated for each motor-unit. (Both
motor-units of a tandem system* must be connected when going through items CH3).
1 - Preparing motor-unit (p. 11).
2 – Programming the curtain end-positions (CH3).
3 – Before coupling the motor-units (BUS): adjusting the end-motors (CH5).

Overview of components in the underside of the motor-unit

POWER SUPPLY
- 24V DC
- Connection for transformers
6230-1000 (6200) (standard)
6330-1000 (6300) (standard)
DIN power supply
Button
Open 1
Button
Close
*) tandem system: consists of two motor-units on a single rail (6200 only).
LED's with switch function
- Light up in green or red
- Give feedback while programming the motor-unit:
See chapter B6 for an overview of the LED signals.
- LED switch function: can be used to operate the system
as a 2-button switch.
CONNECTOR 2 (black)
2 - RJ45
- For connection infrared / switch / RF-receiver /
BUS cables
CONNECTOR 1 (grey)
- RJ45
- For connection infrared / RS232 / BUS cables

Preparation

2
9