G&D DL-DVI-Vision-IP-Series Installation Und Bedienung Seite 117

How to configure the Freeze mode:
1. Press Ctrl+Num
2. Select the row
The Freeze mode is adjusted separately for each video channel of the user module. The
following options can be adjusted separately for each video channel of multi-channel
devices.
3. Under
Freeze mode
 Freeze mode is disabled (default)
off
 Freeze mode is enabled
on
4. If the Freeze mode is active, press
under Freeze visualization
 shows a coloured frame when disconnected
frame
OSD  shows Frozen and the time passed since disconnection
 shows a coloured frame (
frame+OSD
5. Press F2 to save your settings.
1. Click on
IP Extenders > [All Extenders]
2. Double-click the computer module of the KVM extender you want to con-
figure.
3. Click on the tabs
The Freeze mode is adjusted separately for each video channel of the user module. The
following options can be adjusted separately for each video channel of multi-channel
devices.
4. Under Freeze mode
Disabled (default)
Enabled
5. If the Freeze mode is active, additionally select one or both options available
under Freeze visualization
 shows a coloured frame when disconnected
Frame
OSD  shows Frozen and the time passed since disconnection
6. Click OK to save your changes.
(default) to open the on-screen display.
Console setup and press
press to select on of the following options:
F8
to select one of the options available
F8
:
on the directory tree.
.
Remote > General
select one of the following options (see above):
:
Enter .
) and Frozen (
frame OSD
G&D DL-DVI-Vision-IP-Fiber · 40
Configuration
)