Determining Network Settings Via Service Port; Installing The Device Driver - G&D DL-DVI-Vision-IP-Series Installation Und Bedienung

To make sure that the computer connected to the computer module
( DL-DVI-Vision-IP-Fiber-CPU
during booting, the KVM extender contains a cache function. Even when the com-
puter module or the user module are switched off or the devices are not intercon-
nected, the properties of the most recently connected monitor or a default data block
are provided in the KVM extender.
The monitor's DDC information is usually transmitted one-to-one to the computer.
Should the KVM extender determine that the display cannot be read without errors
or that the entries are invalid, the information is completed or corrected (if possible).

Determining network settings via service port

If you do not know the IP address of an already configured user or computer mod-
ule, you can use the service port of the module to find out the address.
Use any terminal emulator (e.g. Tera Term or PuTTY) to show the log messages of
the modules.

Installing the device driver

Before establishing a connection using the terminal emulator, install the device
driver CP210x USB to UART Bridge VCP
NOTE:
When connected to a service cable, the driver provides the Service port of a
user or a computer module as a virtual serial interface (COM port). The virtual
interface can then be selected to establish a connection using the terminal emula-
tor.
How to install the device driver to address the service port:
1. Use any web browser to open the website
2. Go to Downloads > Tools & Driver
3. Download the device driver for the operating system installed on the computetr.
4. Execute the file and follow the instructions of the installation wizard.
) can already access the features of the remote monitor
.
www.gdsys.de
.
Further information
.
G&D DL-DVI-Vision-IP-Fiber · 58