Operation - Cameo LED DROPIX 66 Bedienungsanleitung

OPERATION:

NOTE:
Once the LEDDROPIX controller is properly connected and turned on, the
greeting "WELCOME TO CAMEO" is displayed for a short time during the boot
process. After this operation, the controller is ready for use and changes to the
mode that was previously selected.
AUTOMATIC CONTROL MODE (Auto Mode)
In the auto mode, one of the 30 different programs
(Program:01 - Program:30), plus a program where all 30 programs
run in sequence (Program:Mix) can be activated.
Press the MODE button several times if necessary to enter the upper menu of
the display. Now use the UP and DOWN buttons to select the Auto Mode and
confi rm by pressing the
ENTER button. The display now shows Auto Mode Speed.
By pressing the UP or DOWN button, select the menu item Auto Mode Pro-
gram. Confi rm with ENTER. The desired program can now be selected using
the UP and DOWN buttons (Program:01-30 and Program:Mix). Confi rm the input
with ENTER.
Set the running speed of the activated program by now pressing the UP
or DOWN buttons to select the menu item Auto Mode Speed. Confi rm with
AC 220V - 240V / 50Hz
Power Consumption: 50 W
ENTER and then using the UP and DOWN buttons, set the speed to the desired
value (Speed:00 = no movement in the program, Speed:01 = slowest speed,
Speed:99 = maximum speed). Confi rm with ENTER.
To permanently show a scene from a program, set the running speed of the
corresponding program to Speed:01 and at the moment in which the desired
scene is displayed, adjust the running speed to Speed:00. To enable another
program, the running speed must fi rst be set to a value other than Speed:00.
MUSIC CONTROL MODE (Sound Mode)
In the music control mode, the LED curtains are controlled via the built-in
microphone controller and the activated programs follow the beat of the music
(bass pulses). 30 different programs (Program:01 - Program:30), plus a pro-
gram where all 30 programs run in sequence (Program:Mix), are available.
Press the MODE button several times if necessary to enter the the upper menu
of the display. Now use the UP and DOWN buttons to select the Sound Mode
and confi rm by pressing the
ENTER button.
The display now shows Sound Mode Program:xx. The desired program
can now be selected using the UP and DOWN buttons (Program:01-30 and
Program:Mix). Confi rm the input with ENTER.
To adjust the sensitivity with which the LED curtains react to music signals
(bass impulses), select SENSITIVITY on the LEDDROPIX controller. When turned
to the left, the sensitivity is lowered, when turned to the right, it is increased.
13