Initial Configuration Of The Network Settings - G&D ControlCenter-IP Installationsanleitung

Initial configuration of the
network settings
A basic requirement to access the web application is to configure the network set-
tings of the KVM switch on which the web application is operated.
NOTE:
In the defaults, the following settings are pre-selected:
 IP address of network interface A:
 IP address of network interface B: address obtained using
 global network settings: settings obtained using
How to configure the network settings before integrating the device into the local
network:
1. Use a category 5 (or better) twisted pair cable to connect the network interface of
any computer to the device's Network A interface.
2. Ensure that the IP address of the computer's network interface is part of the sub-
net to which the device's IP address belongs to.
NOTE: Use the IP address 192.168.0.100, for example.
3. Switch on the device.
4. Start the computer's web browser and enter the URL
address bar.
5. Click on
Download Config Panel
6. Authenticate your user account against the web application.
NOTE: These are the default access data for the administrator account:
Admin
 Username:
 Password: 4658
Change the preset password of the administrator account. The manual of the
web application provides a detailed description of how to change the preset
access data.
7. Click the tools symbol in the toolbar.
8. Click the
Configuration > Interfaces

Initial configuration of the network settings

192.168.0.1
DHCP
.
tabs.
DHCP
in the
https://192.168.0.1
G&D ControlCenter-IP · 11