Initial configuration of the network
settings
NOTE:
By default, the following settings are preselected:
IP address of Network interface A:
IP address of Network interface B: Obtain address via
global network settings: Obtain settings via
The basic requirement for accessing the web application is the configuration of the
network settings of the device on which the web application is operated.
Establishing a connection to the network interface
How to connect a computer to the network interface of the KVM switch:
1. Use a category 5e (or better) twisted pair cable to connect the network interface
of any computer to the device's Network A interface.
2. Make sure that the IP address of the computer's network interface is part of the
subnet to which the IP address of the device belongs.
NOTE:
Use the IP address 192.168.0.100, for example.
3. Turn on the KVM switch.
Starting the web application
How to configure the settings of a network interface:
1. Start the computer's web browser and enter the URL
2. Enter the following data in the login mask:
Username:
Password:
IMPORTANT:
Change the administrator account's default password.
The default access data to the administrator account are:
Username:
Admin
4658
Password:
Initial configuration of the network settings
192.168.0.1
Enter the username of an administrator account.
Enter the password of the administrator account.
DHCP
DHCP
192.168.0.1
in the address line.
G&D DL-DVI-MUX4-NT · 16