Wiring - SOMFY ilmo 50 WT Anleitung

2. 1. 3. Drive/tube assembly
Slide the motor into the roller tube.
1)
For roller tubes which are smooth inside, position the
notch previously cut on the boss on the crown.
The drive wheel must be locked in place to prevent it
2)
moving along the roller tube:
7KLV FDQ EH GRQH HLWKHU E\ ¿[LQJ WKH UROOHU WXEH WR WKH
‡
GULYH ZKHHO XVLQJ  [ ‘  PP VHOIWDSSLQJ VFUHZV
RU E\ XVLQJ  [ ‘  PP VWHHO SRS ULYHWV SODFHG 
mm to 15 mm from the outer rim of the drive wheel,
regardless of the roller tube.
1
The screws or pop rivets must only be attached to
the drive wheel and not to the drive.
Alternatively, a drive wheel stop can be used for tubes
‡
which are not smooth.
2. 1. 4. Installing the drive/tube assembly
,QVWDOO DQG ¿[ WKH WXEHGULYH DVVHPEO\ RQWR WKH HQG
1)
bracket f and onto the drive bracket g:
1
Ensure that the drive/tube assembly is secured onto
the end bracket. This operation prevents the drive/
tube assembly from coming out of the end bracket
mounting when the roller blind reaches the lower end
limit position.
'HSHQGLQJ RQ WKH W\SH RI EUDFNHW ¿W WKH VWRS ULQJ h
2)
in place.

2. 2. WIRING

Cables which pass through a metal wall must be
protected and isolated using a sheath or sleeve.
Attach cables to prevent any contact with moving
parts.
If the drive is used outdoors, and if the supply cable is a type HO5-VVF cable, the cable
should be installed in a UV-resistant duct, e.g. under a gland.
1
The Ilmo 50 WT cable can be removed. If it is damaged, replace it with an identical cable.
1
Leave the drive power supply cable accessible: it must be possible to replace it easily.
1
Always make a loop in the power supply cable to prevent water entering the drive!
Switch off the power supply.
-
Connect the drive according to the information in the table below:
-
230 V
a Neutral (N)
b Live, direction 1 (P)
c Live, direction 2 (P)
d Earth ( )
Copyright © 2007 - 2014 Somfy SAS. All rights reserved.
50 Hz Cable
Blue
Brown
Black
Yellow/Green
1)
2)
1)
g
2)
h
OFF
Images not contractually binding
15 mm
5 mm
L1
20 mm
f
L ≤ 50 m
b
a
N
c
d
L
3