Wiring; Commissioning; Identifying Setting Steps Already Completed; Pre-Programming The Rts Control Point - Somfy Sunea Csi Rts Gebrauchsanleitung

4. Wiring

- Switch off the power supply.
- Connect the motor according to the information in the
table below :
230 V ~ 50 Hz
Brown
1
Blue
2
3 Green-Yellow

5. Commissioning

This guide describe only the commissioning using a RTS control point as Telis 1 RTS.
For commissioning using other RTS control point, refer to the corresponding guide.

5.1 Identifying setting steps already completed

Only one motor can be powered at a time.
Do not use the Inis RT/Inis RTS control point for
commissioning.
Switch the power on and follow process «a» or «b»
depending on the awning reaction :
The awning makes a brief movement.
a
The end limits are set and no RTS control point is
programmed. Go to chapter « Programming the first
RTS control point ».
or
The awning does not move.
b
Press the Up or Down button and follow process «c» or
«d» depending on the awning reaction.
The awning still does not move
c
The end limits have not been set and no RTS control
point is programmed.
Go to chapter « Pre-programming the RTS control
point ».
or
The awning goes fully up or fully down
d
The end limits have been set and the RTS control
point is programmed.
Go to chapter « Use »

5.2 Pre-programming the RTS control point

- Press the Up and Down button simultaneously: the
awning makes a movement, the RTS control point is
programmed in the motor.
Copyright © 2009 Somfy SAS. All rights reserved.
Motor cable
Live (P)
Neutral (N)
Earth
Sunea CSI RTS
OFF
3 x 0,75 mm 2
1
230 V
2
~
3
50 Hz
3 x 1,5 mm 2
1
2
3
ON
Programming
the first
RTS control point
c
Pre-programming
the RTS control point
Use
or
d
13