Installation; Tube Preparation - SOMFY ilmo 50 WT Anleitung

2. INSTALLATION

1
Instructions which must be followed by the motorisation and home automation professional
installing the ilmo 50 WT drive.
1
Never drop, knock, drill or submerge the drive.
1
Install a separate control point for each motorisation.
1
Never connect 2 control points to a single motor.
2. 1. INSTALLATION
1
&KHFN WKH VWUHQJWK RI WKH UROOHU VKXWWHU DQG LWV ¿WWLQJV
1
Check that the drive used is suitable for the size of roller shutter, to avoid the risk of
damaging the roller shutter and/or the Somfy product.
For information about the compatibility of the drive with the roller shutter and accessories,
contact the roller shutter manufacturer or Somfy.
2. 1. 1. Preparing the drive
Fit the accessories required to integrate the
1)
motorisation in the roller tube:
(LWKHU ¿W WKH GULYH ZKHHO a on the drive.
‡
2U ¿W WKH FURZQ b and the drive wheel c on the drive.
‡
Measure the length (L1) between the inner edge of the
2)
motorisation head and the rim of the drive wheel.

2. 1. 2. Tube preparation

1
Install a ilmo 50 WT motor in a roller tube with a minimum thickness of 0.5 mm and a
smooth inner surface: with no welding, crimping, folding, etc. inside the tube.
Cut the roller tube to the required length, depending on
1)
the motorised product.
Deburr the roller tube and remove the swarf.
2)
For smooth roller tubes, cut a notch with the following
3)
measurements:
d = 4 mm (0.16 in)
‡
e = 28 mm (1.1 in)
‡
2
Images not contractually binding
1)
Ø = 47 mm
2)
1)
3)
Copyright © 2007 - 2014 Somfy SAS. All rights reserved.
Ø > 47 mm
a b c
L1 = ...
L1
2)
d
e