Endress+Hauser iTEMP HART TMT162 Bedienungsanleitung Seite 29

TMT162 HART
Display symbols
Pos. Function
no.
1 Bargraph display
2 Display 'Warning'
3 Engineering unit display K, °F, °C or %
4 Measured value display
(0.81" / 20.5 mm character size)
5 Status and information display
6 Display "Communication"
7 Display "Configuration locked"
4.3.2 Local operation, setup of the hardware
Fig. 9: Hardware setup using jumpers J1, J2 and J3
Endress+Hauser
Description
In 10% steps with overrange and underrange marks.
The bargraph display flashes when an error occurs.
This display mode appears when an error occurs or a
warning is given.
Engineering unit for the measured value being
displayed.
Measured value display. If a warning is present this
display alternates between the measured value and the
warning code. In the event of an error, the error code
is dispalyed instead of the measured value.
Display of which value is being indicated on the
display. On PV a customer specific text can be entered.
On warning, the display shows the warning code as
well as "WARN". On faults the display shows
"ALARM".
The communication icon appears on read or write
®
access using the HART
If the software or hardware setup/configuration is
locked, the "Configuration locked" icon appears.
Commissioning
protocol.
T09-TMT162ZZ-19-00-00-xx-001
29